✨𝓦𝓐𝓣𝓔𝓡 𝓣𝓐𝓟 3𝓻𝓭 𝓔✨

Water tap is a circuit in which we are going imitate a real tap. This circuit will be executed by an Arduino Uno board  previously programmed in arduinoblocks. 

 

✨𝑀𝒶𝓉𝑒𝓇𝒾𝒶𝓁𝓈✨

 

⇨ One LDR + one 10kΩ resistor

⇨ One pump (motor) + one 1kΩ resistor + 1 BD139 transistor + one 9V battery

⇨ One LED RGBs + three 220Ω resistors

⇨ One tilt sensor. 

⇨ Screw Shield 1.0 (to leave the wires immobile)

 

✨𝒞𝒾𝓇𝒸𝓊𝒾𝓉✨

✨𝒞𝑜𝒹𝒾𝓃𝑔✨

✨𝑅𝑒𝒶𝓁 𝒸𝒾𝓇𝒸𝓊𝒾𝓉✨

✨𝒪𝓉𝒽𝑒𝓇 𝓂𝒶𝓉𝑒𝓇𝒾𝒶𝓁𝓈✨

⇒ Two square-shaped tupperware

⇒ Flanges

⇒ Aluminium foil

⇒ Wooden board

First we are going to start making the circuit with the instructions of the beggining, we copy image of the arduino program in the arduinoblocks web. Then we are going to make the circuit in a breadboard to test it like in the image above. Later we are going to transpose the circuit in the Screw Shield 1.0 to have the wires without movility, this will make the work easier to put the components in the structure of the tap. Finally we are going to make the final stucture with the materials said before, and put the circuit in and make it work.

✨𝒞𝒾𝓇𝒸𝓊𝒾𝓉 𝓌𝑜𝓇𝓀𝒾𝓃𝑔✨